East Coast Gear Toyota 7.5" Clamshell Bushing

One Sintered PTFE Bushing, metal backed, bronze inlaid, PTFE coated CV axle bushing for Toyota 7.5" front clamshell differential. Fits 86 to 04 Pickups, T100, Tacoma, 99-06 Tundra and up to 02 4runner. Replaces Driver side CV axle needle bearing with bushing to help control Vibration and shaft float common on these differentials. This is for the bushing ONLY, the removal tool is also an option to allow one to easily remove the stock needle Bearing.

TECH NOTE: The T7.5 bushing is longer than the stock needle bearing. There is room for the bushing to install flush without hitting the spider gear, however some of the toyota carriers are not bored straight through and there is a ridge on the inside. The ridge will stop the bushing from seating flush. Installed height is between .030-.065 off of the carrier bore as acceptable. The bushing can be driven past the ridge of you hit it hard enough but it will damage the bushing and cause the CV shaft not install properly. Drive bushing in to carrier with even firm blows once you feel it stop verify height is between .030 -.065